1/1/2023 0 Comments Rockshox recon 335 manual![]() Want more information? For additional resources like service documents, tuning help, and more, enter your fork serial number or model at the SRAM Service Site or the RockShox Trailhead App.Information may be enhanced without prior notice. Tech Tip: If you are still bottoming out with the desired sag, check out our Bottomless Tokens FAQ. If necessary, readjust the air pressure to reach your target sag position.ĥ) Repeat the sag process until reaching your target sag percentage. ![]() Note the sag percentage where the o-ring stopped. Have your assistant slide the sag o-ring down to the top of the dust wiper seal.Ĥ) Gently step off the bicycle without compressing the fork any further. Then sit or stand in your normal riding position. With riding gear on, and an assistant holding the bike, stand on the pedals and compress the fork three times. Do not compress the suspension with the pump attached.ģ) Solo Air and DebonAir only: Compress the fork through at least 50% of its travel five more times to equalize positive and negative air pressures. Pressurize the air spring to the recommended starting pressure once more. Air pressure equalization ensures the positive air spring is accurately pressurized. Solo Air and DebonAir only: Compress the fork through at least 50% of its travel five times to equalize positive and negative air pressures.Dual Position Air only: Pressurize the fork in the full travel position.IMPORTANT: Do not compress the suspension with the pump attached. Remote: Set the compression damper to the open position.Ģ) Pressurize the air spring to the recommended starting air pressure. Rotate the adjusters counter-clockwise until they stop. ![]() Optimal suspension sag is the result of setting the proper suspension spring rate.įront suspension air pressure recommendations listed on the back of your fork and at RockShox Trailhead are suggestions for initial spring setup.ĭon’t have the air chart decal? Check out our video walkthrough, or follow the process below, as summarized from our Suspension Setup and Tuning Guide.ġ) Set the dampers to the fully open positions before setting the sag. Setting the correct sag allows the suspension to perform effectively. Air pressure in your fork controls sag, the percentage of full travel that the suspension compresses when the rider, including gear, is on the bicycle in a normal riding position. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |